Welcome to our new website, found an issue or bug? Please report it here
FMG84A
LOW FLOW MAGMETER
Added to Your Shopping Cart
Configuration complete.
Please add to cart to keep it or exit the configuration
Please add to cart to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| Accuracy | ± 1 % |
| Accuracy Note | ± 1%, ± 0.005 GPM of reading across |
| Cable Length | 6 m |
| Conductivity | > 20 µS/cm |
| Electrical Connection | 8-pin mini DIN |
| Enclosure Ratings | IP66, NEMA Type 4X |
| K-Factor | 1892 pulses/gal |
| Materials | PVDF |
| Materials, Wetted | PVDF |
| Media Compatibility | Acid Solutions, Conductive Liquids, Saltwater |
| Number of Outputs | 1 |
| Operating Pressure, Max | 150 psi |
| Operating Temperature, Max | 54 °C |
| Operating Temperature, Min | -18 °C |
| Output Detail | Optocoupled current sinking or current sourcing pulse output; 30 Vdc, 5 mA max, 4 to 20 mA current loop; 7 Vdc plus load voltage drop min; 50 Vdc max |
| Output Signal | Current |
| Pipe Size, Max | 0.75 in |
| Process Connection Note | Fittings with two NPT threaded adaptors (included) |
| Process Connection Size | 3/4 in |
| Process Connection Type | NPT Male |
| Process Temperature, Max | 93 °C |
| Process Temperature, Min | 0 °C |
| Supply Power Note | 10 to 15 Vdc, 150 mA (linear power supply recommended) |
| Supply Power Type | DC |
| Supply Voltage | 10 to 15 Vdc |
| Volumetric Flow Rate, Max | 20 GPM |
| Volumetric Flow Rate, Min | 0.2 GPM |
| Weight | 0 lb |
| See All Specs | |
PDFs & Manuals
Show Ratings & Reviews
Rated 4 out of
5
by
Mechanical Engineer from
Great purchase, will purchase again.
Mechanical install was very easy and the included mounting bracket made the install fast. My only issue was the electrical setup which I needed some help with but that was fixed quickly with a phone call to support.
Date published: 2023-12-29
Rated 4 out of
5
by
righton from
The unit works great and is very accurate.
Just 1 question. The unit stops outputting at .3L/min instead of the .1L/min after the conversion from gallons.
Date published: 2017-04-04