Welcome to our new website, found an issue or bug? Please report it here
CDH-93
Resistivity and Conductivity Tester
Added to Your Shopping Cart
Configuration complete.
Please add to cart to keep it or exit the configuration
Please add to cart to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Show Ratings & Reviews
Rated 1 out of
5
by
analytical chemist from
Nonsensical ranges
The advertised range for this probe is 5 uS/cm - 50 mS/cm, which converts to 20 - 20000 Ohm*cm (0.020 - 200 KOhm*cm), yet they claim it has a resistivity range of 0-20 MOhm*cm. This would require conductivity readings to go as low as 0.05 uS/cm. In practice, I can't seem to get a single resistivity reading higher than 3 KOhm*cm. I am working with deionized water that should be around 18 MOhm*cm. This is completely unacceptable equipment for the purposes I needed and if you also need to confirm deionized water purity, do not waste your money on this.
Date published: 2023-01-24
Rated 4 out of
5
by
samm from
Good Tool. Poor instructions. So-so support.
This will be a good tool for the intended purposes. It is easy to use and appears accurate and durable, but the documentation that comes with it is very meager. I called with a few questions. One was answered other wasn't. Didn't receive a return call or a response to an online support question submitted as a follow up.
Date published: 2017-05-02
Rated 5 out of
5
by
Mack Harris from
Wire EDM
I use this tester to verify my water conductivity for wire EDM it easy to use and fast
Date published: 2021-02-16