Welcome to our new website, found an issue or bug? Please report it here
DA084-Series
Vent Plug IP55
- High Degree of Protection
- Easy to Install
- IP55
DA084-Series
From
$
13.39
Product Overview
- Additional Features 1 With gasket
- Air Interface 7 cm²
- Cover N/A
- Diameter 66 mm
- Enclosure Ratings IP55
- Fitting position Variable
- Height 0 mm
- Length 0 mm
- Mounting PG 29 thread with union nut
- Operating Temperature, Max 70 °C
- Operating Temperature, Min -45 °C
- Pack Size 1
- Weight 62 g
- Width 31 mm
- Works With Pressure Compensation Plug DA084
It has become more and more important to provide a protected enclosure environment for valuable and crucial electrical and electronic components. In a tightly closed enclosure, pressure differentials can occur during extreme temperature variations, such as day/night operation. When this occurs, the risk of dust and humidity being absorbed into the control panel increases dramatically. The specially designed pressure compensation plug DA084 permits a controlled change in pressure. It can be installed easily in any enclosure. Because of the pressure compensation plug’s high degree of protection IP55, the protection type of the enclosure will not be affected.
SPECIFICATIONS
Mounting: PG 29 thread with union nut
Material: Plastic according to UL94 V-0
Air Interface: Approx. 7 cm² (2.8 in²)
Dimensions: à˜ 66 x 31 mm (2.6 x 1.2')
Fitting Position: Variable
Operating/Storage Temperature: -45 to 70°C (-49 to 158°F)
Installation: Make cut-out à˜ 37 + 1 mm (1.5 + 0.03') in enclosure wall and mount pressure compensation device with nut. Please make sure that the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to use two devices on opposite sides towards the top of the enclosure.
SPECIFICATIONS
Mounting: PG 29 thread with union nut
Material: Plastic according to UL94 V-0
Air Interface: Approx. 7 cm² (2.8 in²)
Dimensions: à˜ 66 x 31 mm (2.6 x 1.2')
Fitting Position: Variable
Operating/Storage Temperature: -45 to 70°C (-49 to 158°F)
Installation: Make cut-out à˜ 37 + 1 mm (1.5 + 0.03') in enclosure wall and mount pressure compensation device with nut. Please make sure that the sealing gasket is put in place on the outer side panel of the enclosure. For optimal pressure compensation we recommend to use two devices on opposite sides towards the top of the enclosure.
PDFs & Manuals
