Welcome to our new website, found an issue or bug? Please report it here
TX206TH
Thermistor Temperature Transmitter
Choose a Variant
Input Type
Volume discounts available
Volume Discount Schedule
| Quantity | Price each |
|---|---|
| 1-4 | C$141.82 |
| 5-9 | C$134.73 |
| 10-24 | C$131.89 |
| 25-49 | C$126.22 |
| 50-99 | C$123.38 |
| 100+ | C$120.55 |
Added to Your Shopping Cart
Configuration complete.
Please add to cart to keep it or exit the configuration
Please add to cart to keep it or exit the configuration
Failed to Save Configurations, Click on Configure Button Start Again
Product Specs
<< See all Product Models| Brand |
 |
| Accuracy | ± 5 µA |
| Accuracy Note | (mA output/2000) or 5 uA (whichever is the greater) |
| Calibration | Pushbutton/Software |
| Diameter | 43 mm |
| Electrical Connection | Screw Terminal |
| Electrical Output | 4 to 20 mA |
| Height | 21 mm |
| Humidity Range | 10 to 90% RH non condensing |
| Input Accuracy | ± 0.2 % |
| Input Control Signal | N/A |
| Input Type | Thermistor |
| Operating Temperature, Max | 85 °C |
| Operating Temperature, Min | -40 °C |
| Output Detail | 2-wire (4 to 20) mA current loop Maximum Output: 21.5 mA Minimum Output: <3.75 mA |
| Output Load | [(Vsupply-10)/21] kΩ |
| Probe Length | 0 mm |
| Programmable Functions | offset, Range, Sensor Burnout Indication, sensor type |
| Response Time | 1 sec |
| Self Heating Effect | 0.2 uA/V |
| Sensor Type | Transmitter |
| Setup Controls | Pushbutton/Software |
| Sheath Material | N/A |
| Span, Min | 5°C |
| Start Up Time | I out < 4 mA during start up |
| Storage Temperature, Max | 90 °C |
| Storage Temperature, Min | -50 °C |
| Supply Power Type | DC |
| Supply Voltage | 10 to 30 Vdc |
| Temperature Input Range | N/A |
| Thermal Effects | ± 2 uA/°C, ± 0.02 %/°C |
| Thermocouple Type | N/A |
| Warm Up Time | 1 min to full accuracy |
| Weight | 31 g |
| See All Specs | |
PDFs & Manuals
Software & Drivers
Show Ratings & Reviews
Rated 5 out of
5
by
Sarg from
universal generic programmable transmitter
I purchased this with the hope I could program it to my own NTC thermistor which I succeeded in doing with a resistor decade box, power supply, and milliamp meter. It will monitor motor stators on a semi-hermetic compressor. Thermistor transmitters are hard to find. I was lucky to find this one. It can be programmed in less than a minute once you are set up.
Date published: 2019-04-02