Bienvenue sur notre nouveau site Web, vous avez rencontré un problème ou un bug? Veuillez le signaler ici
CN1504-Series
1/8 DIN 4-Zone & 7-Zone Temperature/Process Controllers with Ramp/Soak Capability
Modèles en stock
- 1/8 DIN Cutout
- ON/OFF and Full PID Control
- Independent 7-Segment Ramp/Soak Profile for Each Zone
- Programmable Heating or Cooling Outputs
CN1504-Series
Depuis
C$
695.00
Modèles en stock
L'aperçu du produit
- Channel Display Time Programmable, 1 to 999 seconds
- Cold Junction Error ±0.5°C (10 to 45°C)/±0.9°F (50 to 113°F)
- Control Output N/A
- Current Accuracy ± 0.05%
- Cutout Dimensions 45 x 22 mm
- Data Interface N/A
- Display Size 10 mm (.39 in)
- Form factor 1/8 DIN
- Frequency 50/60 Hz
- Front Bezel 65 H x 117 W x 178 D mm
- Input Type Note J, K, T, E, R, S, B, thermistor, RTD, 4 to 20 mA loop current, 0 to 10 Vdc, and 0 to 100 mV
- Offset 0 to 100 mV, 0 to 10 mV, 0 to 20 mA
- On/Off Deadband Programmable, 0 to FS
- Output Detail 5 Volts drive @ 50 mA open collector
- Proportional Band 0 to 100% of span
- Ramp and Soak 7-segment programmable for each channel
- Reset 0.00 to 50.00 repeats/minute
- Scale Programmable, 1 to 30,000
- Scan Rate 2 channels/sec (non-adjustable)
- Voltage Accuracy 0.0005
- Weight 992 g
Description
The CN1500 series is a compact unit that offers the features of up to seven controllers in a single 1/8 DIN enclosure.Careful design, high functionality and compactness allow it to offer the best cost/performance ratio of any controller in its class. The input type for each zone is selected independently. Scaling and offset allow current and voltage signals to be converted and displayed in engineering units. Temperature can be displayed in Centigrade or Fahrenheit.
Each zone has its own ramp/soak profile with up to 7 segments. ON/OFF as well as PID control is offered for optimum process stability. Processes that do not require tight control through complex tuning of PID parameters can be run under simple ON/OFF control. Each zone has its own set of ON/OFF and PID parameters and each zone can be programmed for heating or cooling. Setpoint deviation, positive as well as negative, can be viewed.
Additional functions include min/max reading for each zone, indefinite program hold, automatic scanning and displaying of different zones and three display modes (setpoint only, process only or both setpoint and process). Power, control, and process signal connections are conveniently made with Euro-style plug-in connectors.
Each zone has a three-digit long engineering label that can be programmed to indicate the type of process being controlled, e.g., °C or °F for temperature, PSI for pressure, etc. Every controller’s output status is indicated by LED’s. Channel-to-channel scan time is also programmable.
PDF et manuels
Afficher les notes et les avis
Are the thermocouple inputs configured for bare wires or thermocouple plugs (standard or mini)?
Thank you for your inquiry. This instrument is configured to accept stripped leads and has a screw terminal block on rear of unit. Please refer to the online manual for more details.
Date published: 2020-04-30